|
Ways
to
CUT CYCLE TIME /
MOLD BETTER PARTS
|
|
PART 2 - SPIRAL-PASSAGE Barrel End Caps |
|
The more gradual compressing of the material, plus the resulting coanda effect (that is, the phenomenon of material flow tending to follow closely along the wall contour of a passage), greatly eased the strain on the plastic’s molecules and the effects on the material’s inherent properties.
In 1986, IMS first used this technology in the development of their revolutionary SPIRAL End Caps. The results, as projected, were impressive. Parts were stronger and more dimensionally stable. Older presses equipped with these new end caps were actually producing higher quality parts than new presses with traditional style caps.
|
 |
|
|
IMS Exclusive SPIRAL Retrofit Components can improve the performance of
ANY injection press regardless of age, make or model.
They can also SIGNIFICANTLY INCREASE YOUR BOTTOM LINE. |
- NOTE -
Each component can be purchased separately to improve specific molding problems.
For OPTIMUM PERFORMANCE, install every component as a complete injection press upgrade! |
| FOR QUESTIONS OR ASSISTANCE IN SPRIAL COMPONENT SELECTION, contact William Kramer e-mail: wkramer@www.imscompany.com or phone: 440-543-1615 ext. 133 |
SPIRAL™ is a trademark of IMS Company
BRODY-ring® in a registered trademark of IMS Company |
|